Check the following parameters:

db2 get dbm cfg | grep -i discover
Discovery mode (DISCOVER) = SEARCH
Discover server instance (DISCOVER_INST) = ENABLE
db2 get db cfg | grep -i discover
Discovery support for this database (DISCOVER_DB) = ENABLE



-----Original Message-----
From: DanLuchinski
[mailto:db2udbdba-ezmlmshield-x69240380.[Email address protected]
Sent: Wednesday, May 14, 2008 11:55 AM
To: LazyDBA Discussion
Subject: Database not showing up in Control Center

I'm using DB2 9.1.3 on Windows.

From a DB2 command window, I issued commands to catalog a remote system,
catalog the remote instance, and catalog the database. After each
statement, I received the message that it was successful, but the
changes might not show up until the database cache is cleared or
refreshed or something like that.

When I go into the Control Center, I can see the Server and the
Instance, but the database doesn't show up. I can see the database if I
issue a list database directory. I can also connect to the database.

Any idea why I can't see the database in Control Center?

Thanks,

Dan Luchinski
Database Administrator
ASPCA Knowledge Management Center
University of Illinois Allied Agency
Phone: 217.337.9777 Fax: 217.337.0599 Web: www.aspca.org


---------------------------------------------------------------------
TO REPLY TO EVERBODY , PLEASE CLICK REPLY-ALL, NOT JUST REPLY To post a
dba job: http://jobs.lazydba.com To Subscribe : http://www.LazyDBA.com
To unsubscribe: http://www.lazydba.com/unsubscribe.html



DB2 & UDB email list listserv db2-l LazyDBA home page