1. Make sure that the db has stopped by issuing
db2 connect to <db>
2. If it complains 'No database start command issued', then run
db2_kill
3. Run
ipclean
two/three times.
3. Then issue db2start.
This should bring the engine up. Let me know if you have any problems.
Partha



-----Original Message-----
From: Keith Williams
[mailto:db2udbdba-ezmlmshield-x70354650.[Email address protected]
Sent: Tuesday, November 30, 2004 1:18 PM
To: LazyDBA Discussion
Subject: db2 won't stop


db2 was using 100% of the CPU, so I issued a db2 stop from the control center, but db2 has not stopped.
I killed the process that was consuming all the cpu. how can I restart (stop and start) db2?

TIA

-----------------------------------------------------------
Keith Williams
Troux Technologies
8601 FM 2222, BLDG 3, STE 300
Austin, TX 78730
(512) 536-6270
-----------------------------------------------------------
This email and any attachments thereto may contain private, confidential, and privileged material for the sole use of the intended recipient. Any review, copying, or distribution of this email (or any attachments thereto) by others is strictly prohibited. If you are not the intended recipient, please contact the sender immediately and permanently delete the original and any copies of this email and any attachments thereto.
-----------------------------------------------------------




---------------------------------------------------------------------
PLEASE CLICK REPLY-ALL TO SEND A REPLY TO EVERYONE
website: http://www.LazyDBA.com
To unsubscribe: http://www.lazydba.com/unsubscribe.html


DB2 & UDB email list listserv db2-l LazyDBA home page